Abstract: Low attenuation, low dispersion of optical waveguides are provided by a process initiating with axial deposition of a high velocity core soot stream impinging on a target at a high angle of incidence relative to the axis of rotation of the target. A core cylinder is built up axially by relative movement between the soot stream and target during deposition, the movement being non-constant in order to maintain a substantially constant diameter with a constant deposition rate. A cladding layer is then built up by deposition of soot radially on the core. Subsequent drying and sintering provides a vitreous preform which may be drawn directly into optical waveguides. Alternatively, the sintered product may be drawn down to smaller rods, which then are covered with further deposited soot cladding to a desired final thickness, and after further drying and sintering may be drawn to optical waveguides.

Abstract: An optical waveguide that has low (0.16 to 0.28 db/km) attenuation but can be subjected to sharp radii of curvature of the order of 2 mm has an index of refraction difference between core and cladding of less than 0.75% and a cutoff wavelength that is 50 micrometers or more greater than the operating wavelength. The waveguide is a "virtual single mode" device, because even though a second order mode can be sustained in the waveguide, the waveguide length or bending losses, or both, differentially attenuates the second order mode so that the primary mode strongly predominates and both modal noise and attenuation are within acceptable limits.

Abstract: Low attenuation, low dispersion of optical waveguides are provided by a process initiating with axial deposition of a high velocity core soot stream impinging on a target at a high angle of incidence relative to the axis of rotation of the target. A core cylinder is built up axially by relative movement between the soot stream and target during deposition, the movement being non-constant in order to maintain a substantially constant diameter with a constant deposition rate. A cladding layer is then built up by deposition of soot radially on the core. Subsequent drying and sintering provides a vitreous preform which may be drawn directly into optical waveguides. Alternatively, the sintered product may be drawn down to smaller rods, which then are covered with further deposited soot cladding to a desired final thickness, and after further drying and sintering may be drawn to optical waveguides.