Abstract: An integrated optical beam steering device includes a planar dielectric lens that collimates beams from different inputs in different directions within the lens plane. It also includes an output coupler, such as a grating or photonic crystal, that guides the collimated beams in different directions out of the lens plane. A switch matrix controls which input port is illuminated and hence the in-plane propagation direction of the collimated beam. And a tunable light source changes the wavelength to control the angle at which the collimated beam leaves the plane of the substrate. The device is very efficient, in part because the input port (and thus in-plane propagation direction) can be changed by actuating only log2 N of the N switches in the switch matrix. It can also be much simpler, smaller, and cheaper because it needs fewer control lines than a conventional optical phased array with the same resolution.

Abstract: An electro-optic modulator imparts the information contained in an electrical signal traveling along a transmission line onto an optical carrier by using signal-related variations in the electrical signal's voltage to modulate the refractive index or absorption in an electro-optic material through which the optical carrier propagates. For optimal bandwidth and modulation efficiency, the microwave and optical waves should be matched in velocity. However, conventional microwave transmission lines have a microwave velocity that is somewhat higher than the optical group velocity in typical optical waveguides. Tuning a microwave transmission line's capacitance reduces the microwave velocity, but also reduces the impedance below the 50? impedance of most microwave components. Conversely, tuning the microwave transmission line's inductance makes it possible to match the microwave velocity to the optical group velocity over bandwidths of 100 GHz or greater while maintaining a microwave impedance of 50?.

Abstract: The accelerometers disclosed herein provide excellent sensitivity, long-term stability, and low SWaP-C through a combination of photonic integrated circuit technology with standard micro-electromechanical systems (MEMS) technology. Examples of these accelerometers use optical transduction to improve the scale factor of traditional MEMS resonant accelerometers by accurately measuring the resonant frequencies of very small (e.g., about 1 ?m) tethers attached to a large (e.g., about 1 mm) proof mass. Some examples use ring resonators to measure the tether frequencies and some other examples use linear resonators to measure the tether frequencies. Potential commercial applications span a wide range from seismic measurement systems to automotive stability controls to inertial guidance to any other application where chip-scale accelerometers are currently deployed.

Abstract: An electro-optic modulator imparts the information contained in an electrical signal traveling along a transmission line onto an optical carrier by using signal-related variations in the electrical signal's voltage to modulate the refractive index or absorption in an electro-optic material through which the optical carrier propagates. For optimal bandwidth and modulation efficiency, the microwave and optical waves should be matched in velocity. However, conventional microwave transmission lines have a microwave velocity that is somewhat higher than the optical group velocity in typical optical waveguides. Tuning a microwave transmission line's capacitance reduces the microwave velocity, but also reduces the impedance below the 50? impedance of most microwave components. Conversely, tuning the microwave transmission line's inductance makes it possible to match the microwave velocity to the optical group velocity over bandwidths of 100 GHz or greater while maintaining a microwave impedance of 50?.