Abstract: A method and system for measuring an amount of power reduction is provided. A percentage or absolute reduction from full power is calculated. The percentage or absolute reduction in power is determined from voltage and current duty cycle information extracted from a comparison of the source waveform to a reference waveform.

Abstract: An AC voltage reduction system and method providing highly efficient reduction of utility voltage with minimal electromagnetic interference is provided. The systems and methods may also be used to improve overall facility power factor. The AC voltage provided to a load, such as a group of lighting ballasts connected on a single circuit, is reduced by a controllable switch coupled in parallel with a capacitor between the AC source and the load. The switch is controlled to turn-on when the voltage across the capacitor is very close to zero and turn-off prior to the next zero-crossing of the line current. The turn-off time is selected in an open loop configuration independently of a measured characteristic of load voltage or watts. In order to provide proper operation of gas discharge lighting, the switch is initially turned off just in advance of the AC source current zero-crossing.

Abstract: Apparatus and methods for AC power regulation for a wide range of complex capacitive and inductive loads which provide substantial reduction in power consumption while also providing a leading power factor. The system is self-adjusting for a wide range of loads and can reduce power consumption by 25 percent in lighting loads while producing minimal reduction in light output. The system utilizes a main switch consisting of back-to-back MOS Controlled Thyristor devices (MCTs) and a parallel capacitor bank in series with the load. The main switch is initially turned off slightly in advance of the load current zero crossing, and this in combination with the capacitor bank allows power to be reduced in a low noise fashion. The turn-off time is advanced gradually to regulate power at a target reduced level. At the target power level, load phase angle is measured and maintained to control the power savings ratio.